Page 1 of 1
How do you create a negative Polarity body in Part design?
Posted: Thu Nov 10, 2016 12:48 pm
by milind
Hello all,
Can we create a negative Polarity body in Part design?
Thanks
Milind
Re: How do you create a negative Polarity body in Part design?
Posted: Thu Nov 10, 2016 1:05 pm
by lalsingh
Hey Milind, I am Lalsingh,
To create negative Polarity firstly you have to insert body and then you can perform negative Feature Like Pocket, Cut, Grove, Slot Etc.
Re: How do you create a negative Polarity body in Part design?
Posted: Fri Jan 13, 2017 4:21 pm
by nitin
Hey Milind, I am Nitin.
Negative polarity body is created by pocket, groove, slot and removed multi-section solid command in the inserted body. Which is only used negative command in that body.
Thanks
Re: How do you create a negative Polarity body in Part design?
Posted: Fri Jan 20, 2017 2:32 pm
by naved
Hi,
I am Naved
First insert body and then use negative command like pocket this command behave like a pad this type of body is called negative polarity body.
Thanks