Page 1 of 1
How can you make a spring, spiral or screw thread ?
Posted: Mon Oct 24, 2016 8:20 pm
by nitin
Hello can we make a spring, spiral or screw thread ? if yes then how ?
Thanks
Re: How can you make a spring, spiral or screw thread ?
Posted: Mon Oct 24, 2016 8:42 pm
by sameer
Hello,
You can use sweep command to create. Just you have to draw helix and a circle then circle has to follow the helix profile.
Re: How can you make a spring, spiral or screw thread ?
Posted: Tue Jan 24, 2017 6:36 pm
by rajesh
Hi,
I'am Rajesh
First you can make Helix press H command in command bar > Enter > specify center point, radius and Length Then create a plane on that point make circle and use sweep command. This command first select circle > Enter > Helix >Enter.
Thanks
Re: How can you make a spring, spiral or screw thread ?
Posted: Sat Jan 28, 2017 11:26 am
by nitin
Re: How can you make a spring, spiral or screw thread ?
Posted: Tue May 09, 2017 8:05 pm
by devansh
Hi
I'am Devansh,
Make a circle- Go to draw panel > Click circle command > Specify center point and specify circle radius and diameter.