DAuto forum

Hello friends,
when i use fillet command and try to fillet some object which is in contact with some other object than it shows trim ribbons. what is that please help me to find it out.


Thanks.

Trim ribbon is use to remove an overlapping material in edge fillets by using trim ribbons we can trim the over lapping solid.

Hi!!!
I am Hareesh,
The trim ribbon feature is used in Edge fillet command to cut the resulting intersecting filleted edge so that we can create overlapping fillets of two different solid

Hello!!!!
I am Navjot,
It is seen some time that we gives fillet to two near bodies and the resulting fillet are intersects with each other, to allow generate this type of fillet you’ll have to mark the trim ribbon feature.