Page 1 of 1

Why we do draft analysis

Posted: Tue Jul 25, 2017 7:24 pm
by Kusum
hiiiii I am kusum, my question is why we do draft analysis ?

Re: Why we do draft analysis

Posted: Wed Jul 26, 2017 1:05 pm
by Kamlesh
Hiii kusum,
When we design a component, which is going to be manufacture by Molding process or we say that injection molding, casting etc.
Over there to make a proper clearance between Component and Mould we give draft on component walls. For example Ice Cube, they do have a draft on their side faces. So they can easily pull out when we slightly twist the ice tray.