Difference between Pocket command and Hole command?
Posted: Thu Jul 27, 2017 6:56 pm
Hello every one,
This is murari doing engineering in Automobile, for designing purpose I am learning Catia, It’s a quite intrusting tool. But while working on it I have a doubt which is not cleared yet and the doubt is, Pocket command and Hole command act as a same then what is the purpose to differentiate this in two commands, and if there is a reason then what is the difference between these two.
This is murari doing engineering in Automobile, for designing purpose I am learning Catia, It’s a quite intrusting tool. But while working on it I have a doubt which is not cleared yet and the doubt is, Pocket command and Hole command act as a same then what is the purpose to differentiate this in two commands, and if there is a reason then what is the difference between these two.