DAuto forum

Hi Friend i'am Maroof,
I'am facing a problem while working in CATIA, actually the size of all Planes are too small some time it becomes very difficult to recognize it, so is it possible to enlarge thees Planes?
if yes, so how

Hello maroof
I'am Sachin,
You can change the size of planes by following this step-
Tool Option Infrastructure Part Infrastructure than go to the Axis system display size.

Hi sachin you tried best but i couldn't find the axis system display Size, where is it?

Ok Maroof you have almost reached at right command I elaborate it, when you go on Part Infrastructure so you will find a tab Named as Display beside the General tab, now you can see a option as Axis System Display Size.
I hope now you understand if not, so you can ask again.

I got it sachin
Thank yo so much.