Hi!
I was questioned while facing a mock test and I doubt replied wrong by saying yes since I am less aware of CATIA commands and functioning. Hope to see the answer
Is It Possible to enter in to Sketcher Workbench directly?
-
- Posts: 1
- Joined: Mon Jun 06, 2016 6:40 pm
-
- Posts: 29
- Joined: Sat Oct 15, 2016 2:44 pm
Re: Is It Possible to enter in to Sketcher Workbench directly?
Hello Arvindo,
Yes ofcourse you can enter directly in sketcher just you have to follow the procedure:
1) Click on start
2) Mechanical Design
3) Sketcher
4) Then only you have to select the desired plane to sketch...
Hope you under stand.
Yes ofcourse you can enter directly in sketcher just you have to follow the procedure:
1) Click on start
2) Mechanical Design
3) Sketcher
4) Then only you have to select the desired plane to sketch...
Hope you under stand.
-
- Posts: 20
- Joined: Mon Oct 24, 2016 3:38 pm
Re: Is It Possible to enter in to Sketcher Workbench directly?
Hi
I am Murari,
Yes, you can switch any time from any workbench to Sketcher or other.
I am Murari,
Yes, you can switch any time from any workbench to Sketcher or other.
Who is online
Users browsing this forum: No registered users and 1 guest