Hello can we make a spring, spiral or screw thread ? if yes then how ?
Thanks
How can you make a spring, spiral or screw thread ?
-
- Posts: 44
- Joined: Sat Oct 15, 2016 2:39 pm
-
- Posts: 28
- Joined: Sat Oct 15, 2016 2:43 pm
Re: How can you make a spring, spiral or screw thread ?
Hello,
You can use sweep command to create. Just you have to draw helix and a circle then circle has to follow the helix profile.
You can use sweep command to create. Just you have to draw helix and a circle then circle has to follow the helix profile.
-
- Posts: 29
- Joined: Sat Oct 15, 2016 2:40 pm
Re: How can you make a spring, spiral or screw thread ?
Hi,
I'am Rajesh
First you can make Helix press H command in command bar > Enter > specify center point, radius and Length Then create a plane on that point make circle and use sweep command. This command first select circle > Enter > Helix >Enter.
Thanks
I'am Rajesh
First you can make Helix press H command in command bar > Enter > specify center point, radius and Length Then create a plane on that point make circle and use sweep command. This command first select circle > Enter > Helix >Enter.
Thanks
-
- Posts: 44
- Joined: Sat Oct 15, 2016 2:39 pm
Re: How can you make a spring, spiral or screw thread ?
Thank you to all.
-
- Posts: 19
- Joined: Mon Oct 24, 2016 3:11 pm
Re: How can you make a spring, spiral or screw thread ?
Hi
I'am Devansh,
Make a circle- Go to draw panel > Click circle command > Specify center point and specify circle radius and diameter.
I'am Devansh,
Make a circle- Go to draw panel > Click circle command > Specify center point and specify circle radius and diameter.
Who is online
Users browsing this forum: No registered users and 1 guest