Page 1 of 1
How many mating constraints are there in assembly?
Posted: Mon Oct 24, 2016 3:11 pm
by anita
Hello all,
How many mating constraints are there in assembly ?
Thanks
Re: How many mating constraints are there in assembly?
Posted: Mon Oct 24, 2016 8:13 pm
by sameer
There are mainly eight mating constraints in assembly. Mate, Align, Angle, Parallel, Perpendicular, Center, Center, Distance and Tangent.
Re: How many mating constraints are there in assembly?
Posted: Mon Jul 24, 2017 12:07 pm
by ganesh
Hello my name is Ganesh,
I was using Assembly workbench In UG, over there I found a tool Assembly Cut. I didn’t know how to use that tool and where it will going to use. So please tell how It will going to be operate and where.
Re: How many mating constraints are there in assembly?
Posted: Mon Jul 24, 2017 1:49 pm
by siddesh
Hello
These is siddesh-
I didn’t know much about it but assembly cut feature is used for Add a hole or another type of cut out through multiple components of Assembly.