Page 1 of 1
What is the use of Remote force in Workbench?
Posted: Thu Nov 03, 2016 11:55 am
by Urooj
Hello All,
I am Urooj, very new to Ansys Workbench. I have seen Remote force command but not able to apply on geometry, can anyone help me in this ?
Re: What is the use of Remote force in Workbench?
Posted: Thu Nov 03, 2016 12:25 pm
by Murari
Hi Urooj,
Remote force is used when we have to apply force at certain distance from the solid body.
Ex: if 10 m beam is there and we fix its one end and we want to apply load on 20 m distance then we can use remote force. to apply the force on 20m.
Hope you understand.
Re: What is the use of Remote force in Workbench?
Posted: Sat Jan 21, 2017 2:58 pm
by tanmay
Hi,
I'am Tanmay
Remote force generally applied on the surface from a distance. If there is multiple body under load than the force is distributed equally.
Thanks
Re: What is the use of Remote force in Workbench?
Posted: Mon Jan 30, 2017 11:09 am
by Urooj
Thank you Helping me.
Re: What is the use of Remote force in Workbench?
Posted: Fri Feb 10, 2017 11:20 am
by Urooj
Hello all,
Can anyone tell me how can I apply Remote force on a sphere center? And the applied force must be equally distributed all over the surface.
Hoping to get reply soon.