Differences between Isometric view & Orthographic view?

Open discussion forum of all kind of engineering design, relevant questions, answers, topics, 2D, 3D, where engineering students or professionals may share their trouble, experience or solutions . (Avoid Spam)
Post Reply
Priyanka
Posts: 28
Joined: Mon Oct 24, 2016 3:05 pm

Differences between Isometric view & Orthographic view?

Postby Priyanka » Wed Oct 26, 2016 4:34 pm

Hello all,

Differences between Isometric view & Orthographic view?
Top
FARHAN
Posts: 18
Joined: Mon Oct 24, 2016 3:30 pm

Re: Differences between Isometric view & Orthographic view?

Postby FARHAN » Wed Oct 26, 2016 6:08 pm

Isometric view and orthographic are placed in different angle to each other. Both of them represents 3D view in 2D drawing sheet.
Top
Hareesh
Posts: 42
Joined: Mon Oct 24, 2016 2:58 pm

Re: Differences between Isometric view & Orthographic view?

Postby Hareesh » Mon Jan 23, 2017 6:09 pm

Hi, I am Hareesh.
Isometric projection is a projection. Which is used to represent 3D view in top, front and side section in a single view. That view is shown by three axis. And two axis of them have 120* angle.
Orthographic projection is a projection. Which is used to represent 3D view in separate top, front and side view. That view is shown by two axis. And these axis have 90* angle. So it is also called parallel projection.
Top
Post Reply

Return to “Engineering Design (2D 3D)”

Who is online

Users browsing this forum: No registered users and 0 guests